| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A security flaw has been discovered in zhayujie CowAgent up to 2.2.0. This affects an unknown part of the file Markdown.tsx of the component Markdown Rendering. The manipulation results in denial of service. It is possible to launch the attack remotely. The exploit has been released to the public and may be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was identified in zhayujie CowAgent up to 2.2.0. Affected by this issue is the function json.loads of the component Streaming Tool-Call Argument Handler. The manipulation leads to allocation of resources. It is possible to initiate the attack remotely. The exploit is publicly available and might be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| The Bluetooth Link Layer Control Procedure (LLCP) implementation for Connected Isochronous Stream (CIS) creation retains an RX node (ctx->node_ref.rx, marked NODE_RX_TYPE_RETAIN) so it can later be reused as the host notification — on the peripheral while awaiting the Host's reply to an LL_CIS_REQ, and on the central for the whole duration of a locally initiated CIS Create. In subsys/bluetooth/controller/ll_sw/ull_llcp_cc.c, the "invalid PDU received" paths of llcp_rp_cc_rx() and llcp_lp_cc_rx() terminated the connection and completed the procedure without releasing that retained node, breaking the invariant checked in llcp_lr_check_done() and llcp_rr_check_done() and orphaning the node's memory.
A peer device within radio range can reach this with a single extra LL Control PDU on an unauthenticated, unencrypted ACL link. Against a peripheral, the attacker sends a valid LL_CIS_REQ and then, before the Host replies, any unrelated LL Control PDU (for example LL_VERSION_IND), which ull_cp_rx() routes into the active remote procedure. Against a central performing a CIS Create, a malicious peripheral answers with LL_UNKNOWN_RSP for CIS_REQ, which is dispatched into the active local procedure. No pairing, encryption or user interaction is required; the code is compiled in when CONFIG_BT_CTLR_PERIPHERAL_ISO or CONFIG_BT_CTLR_CENTRAL_ISO is enabled.
In default builds (CONFIG_BT_CTLR_ASSERT_DEBUG is default y) the retained-node assertion fires immediately, producing a controller fatal error and, typically, a system reset from one injected PDU. With the development assertions disabled, each attempt permanently loses one node from the controller's small LL notification pool (LL_PDU_RX_CNT, 2 * CONFIG_BT_CTLR_LLCP_CONN) together with its memq_link_t; repeating the connect-attack-reconnect cycle exhausts the pool, after which notification allocation always fails, RX flow control stalls, and the non-disableable LL_ASSERT_ERR() in llcp_lp_cc_flush() faults. The impact is limited to availability — the leaked node is orphaned, never reused or double-freed — and recovery requires a reboot. |
| The Bluetooth Link Layer control procedure code in subsys/bluetooth/controller/ll_sw/ull_llcp_conn_upd.c retains the received RX node while a Connection Update / Connection Parameter procedure waits for its instant, so the node can later carry the host notification (llcp_rx_node_retain(), which marks it NODE_RX_TYPE_RETAIN and thereby suppresses the normal recycling in ull.c). The default: arm of llcp_rp_cu_rx() and llcp_lp_cu_rx() — the "invalid PDU, terminate the connection" path — completed the procedure without releasing that retained node. llcp_rr_check_done() then dequeued and freed the procedure context with ctx->node_ref.rx still pointing at the retained node, dropping the last reference to it.
A peer device in radio range can reach this without pairing, bonding, or encryption. Against a peripheral, the peer sends a well-formed LL_CONNECTION_UPDATE_IND with an instant a few connection events in the future (the node is retained and the procedure enters RP_CU_STATE_WAIT_INSTANT), then, before the instant is reached, sends any other LL Control PDU such as LL_LENGTH_REQ. ull_cp_rx() routes that PDU into the active remote Connection Update procedure, which takes the invalid-PDU path. The central role is reachable symmetrically after accepting an LL_CONNECTION_PARAM_REQ, and the local-procedure variant is reachable with LL_REJECT_IND.
With CONFIG_BT_CTLR_ASSERT_DEBUG enabled (its default), the resulting state violates the invariant asserted in llcp_rr_check_done(), so the two-PDU sequence produces an immediate fatal error in the controller. With those asserts disabled, each occurrence permanently loses one node from the controller's small fixed RX pool (sized from CONFIG_BT_CTLR_RX_BUFFERS, which defaults to 1); repeating the sequence across reconnections exhausts the pool, after which the link-layer receive path operates on a NULL node. The impact is an unauthenticated, remotely triggerable denial of service persisting until reboot; there is no memory-disclosure or memory-corruption consequence, since the leaked node simply becomes unreachable. |
| The Link Layer Control Procedure (LLCP) implementation of the Zephyr software Bluetooth LE Controller retains the receive node that carried an accepted LL_PHY_UPDATE_IND so that it can later be reused for the host notification when the update instant is reached (llcp_rx_node_retain() in subsys/bluetooth/controller/ll_sw/ull_llcp.c, and the node is deliberately not recycled while marked NODE_RX_TYPE_RETAIN). The invalid-PDU arms of llcp_lp_pu_rx() and llcp_rp_pu_rx() in subsys/bluetooth/controller/ll_sw/ull_llcp_phy.c completed the procedure via llcp_lr_complete() / llcp_rr_complete() without first releasing that retained node, so the procedure context — the only remaining reference to the node — was freed while the node was still held out of the receive pool.
A peer device on an established LE connection can drive this deterministically and without pairing or encryption. Against a peripheral it sends LL_PHY_REQ, receives LL_PHY_RSP, sends a valid LL_PHY_UPDATE_IND with an instant a few connection events in the future (so the node becomes retained), and then, before the instant is reached, sends any other LL Control PDU such as LL_LENGTH_REQ; ull_cp_rx() routes it to the active remote PHY Update procedure, which takes the invalid-PDU path. The mirror case applies to a locally initiated PHY Update followed by an LL_REJECT_IND.
In the default configuration (CONFIG_BT_ASSERT and CONFIG_BT_CTLR_ASSERT_DEBUG both default y) the violated invariant in llcp_lr_check_done() / llcp_rr_check_done() triggers a controller assertion, ending in k_oops() (or k_panic()) — a single crafted PDU sequence from radio range faults the device. With those assertions compiled out, each attempt silently leaks one receive PDU node and its memq link; because the controller receive pool is small (PDU_RX_CNT, driven by CONFIG_BT_CTLR_RX_BUFFERS, which defaults to 1) and each attempt costs the attacker only a reconnect, a few repetitions exhaust the pool and leave Bluetooth inoperable until reboot. On releases v3.4.0 through v3.7.x the assertion is never reached, whatever the configuration, so every attempt leaks silently.
The impact is limited to availability: the orphaned node leaves no dangling pointer that is later dereferenced and is never delivered to the host, so there is no memory corruption or information disclosure. The same pull request applies the identical release to the Connection Update and CIS-create procedures, whose invalid-PDU arms had the same omission. |
| The WooCommerce Bookings WordPress plugin before 3.11.0 does not limit a user-supplied value before using it to allocate memory in one of its unauthenticated AJAX actions, allowing unauthenticated attackers to exhaust server memory and cause a Denial of Service with a single request. |
| A security vulnerability has been detected in zhayujie CowAgent up to 2.1.9. The impacted element is an unknown function of the component Media Download Handler. Such manipulation leads to uncontrolled memory allocation. It is possible to launch the attack remotely. The exploit has been disclosed publicly and may be used. Upgrading to version 2.2.0 is sufficient to resolve this issue. The name of the patch is b7967210268fc4c0afea1078223e74e7e96a8a54. You should upgrade the affected component. |
| A weakness has been identified in zhayujie CowAgent up to 2.1.6. The affected element is the function read of the file /upload of the component Web Console. This manipulation causes denial of service. It is possible to initiate the attack remotely. The exploit has been made available to the public and could be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. |
| A security flaw has been discovered in zhayujie CowAgent up to 2.1.7. Impacted is an unknown function of the file channel/web/web_channel.py of the component Web Console. The manipulation of the argument session_id results in denial of service. The attack may be performed from remote. The exploit has been released to the public and may be used for attacks. Version 2.1.7 (commit dec28324) only partly mitigates via a 512MB body cap. The vendor was contacted early about this disclosure. |
| A vulnerability was determined in Konstanty Bialkowski libmodplug up to 0.8.9.1. This issue affects the function abc_add_gchord of the file src/load_abc.cpp of the component ABC Music Format Parser. This manipulation causes resource consumption. The attack may be initiated remotely. The vendor was contacted early about this disclosure but did not respond in any way. |
| ageLANServer provides a cross-platform web server and launcher for offline multiplayer in several Age of Empires and Age of Mythology games. Prior to version 1.15.2, the AoE3 POST /game/cloud/getFileURL handler in the bundled game server has no request body size limit or cap on the attacker-controlled JSON names array and allocates response storage directly from the unbounded array length. A remote unauthenticated client can use the default self-registration flow and send an oversized request that causes excessive memory allocation, crashes or hangs the server process, disconnects active players, and keeps the service unavailable until it is restarted. This issue is fixed in version 1.15.2. |
| yopass is a service for securely sharing secrets, passwords, and files. Prior to version 14.7.0, the Prometheus metrics middleware in pkg/server/server.go uses the attacker-controlled r.Method value directly as the method label for yopass_http_requests_total and yopass_http_request_duration_seconds. Because the catch-all route accepts arbitrary HTTP method tokens, an unauthenticated remote attacker can submit many unique methods and create metric series that the Prometheus registry never evicts. The resulting monotonic memory growth can OOM-kill the process, while the expanding registry also degrades /metrics scrape latency and can blind monitoring. This issue is fixed in version 14.7.0. |
| OpenDocMan 2.4.0 through 2.10.0 contains a decompression bomb vulnerability that allows authenticated users to exhaust PHP memory by uploading crafted office documents. Attackers can upload a small ODT, DOCX, or XLSX file whose XML entries decompress to hundreds of megabytes, crashing PHP workers and degrading availability. |
| Quarkus LangChain4j 1.9.0 through 1.14.1 contains a missing release of memory vulnerability in the chat-scopes WebSocket /_chat/routes endpoint that allows unauthenticated remote clients to exhaust server memory. Attackers can send repeated CONNECT frames reusing one chatId, leaving orphaned scopes in activeScopes until the JVM exits and degrading availability. |
| Strawberry GraphQL is a library for creating GraphQL APIs. From 0.312.3 until 0.327.2, the legacy graphql-ws subscription handler in strawberry/subscriptions/protocols/graphql_ws/handlers.py does not remove naturally completed operations from self.tasks and self.subscriptions. When max_subscriptions_per_connection is configured, a client on a persistent WebSocket connection can use distinct operation IDs for one-shot subscriptions to fill the connection's configured slots even after those subscriptions send complete, causing later legitimate operations on that connection to be rejected with Subscription limit reached. The modern graphql-transport-ws protocol and deployments without the configured per-connection cap are not affected. This issue is fixed in version 0.327.2. |
| OWASP Coraza WAF is a golang modsecurity compatible web application firewall library. From 3.0.0 until 3.8.0, the multipart loop in internal/bodyprocessors/multipart.go executes defer temp.Close() for every uploaded file part, so each temporary-file descriptor remains open until the complete request returns. An unauthenticated attacker can submit a multipart body containing many minimal file parts and exhaust the process file-descriptor table within the request-body size limit, causing os.CreateTemp failures, MULTIPART_STRICT_ERROR responses, blocked legitimate uploads, and process-wide inability to open files or sockets. This issue is fixed in version 3.8.0. |
| SillyTavern 1.12.13 through 1.19.0 contains a denial of service vulnerability that allows unauthenticated remote attackers to exhaust resources because body-parser middleware runs before authentication and whitelist checks. Attackers can send large or compressed JSON or urlencoded bodies up to 500 MB, optionally in parallel, to exhaust memory and CPU and deny service. |
| An issue in libming through 0.4.8 allows a remote attacker to cause a denial of service via the readtag_file() in src/blocks/fromswf.c. |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to 7.1.2-30 and 6.9.13-55, a crafted highly compressed MAT image can make the MAT decoder create temporary files larger than the configured security-policy limit, bypassing resource restrictions and consuming excessive disk space. This issue is fixed in versions 7.1.2-30 and 6.9.13-55. |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to 7.1.2-31 and 6.9.13-56, a missing limit check in the MVG decoder allows a crafted MVG image to trigger an excessively long-running operation. This issue is fixed in versions 7.1.2-31 and 6.9.13-56. |
