| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| When reading a specially crafted TAR archive an Apache Ant build can be made to allocate large amounts of memory that finally leads to an out of memory error, even for small inputs. This can be used to disrupt builds using Apache Ant. Apache Ant prior to 1.9.16 and 1.10.11 were affected. |
| FasterXML jackson-databind 2.x before 2.9.10.4 mishandles the interaction between serialization gadgets and typing, related to org.apache.aries.transaction.jms.internal.XaPooledConnectionFactory (aka aries.transaction.jms). |
| When using the Apache JServ Protocol (AJP), care must be taken when trusting incoming connections to Apache Tomcat. Tomcat treats AJP connections as having higher trust than, for example, a similar HTTP connection. If such connections are available to an attacker, they can be exploited in ways that may be surprising. In Apache Tomcat 9.0.0.M1 to 9.0.0.30, 8.5.0 to 8.5.50 and 7.0.0 to 7.0.99, Tomcat shipped with an AJP Connector enabled by default that listened on all configured IP addresses. It was expected (and recommended in the security guide) that this Connector would be disabled if not required. This vulnerability report identified a mechanism that allowed: - returning arbitrary files from anywhere in the web application - processing any file in the web application as a JSP Further, if the web application allowed file upload and stored those files within the web application (or the attacker was able to control the content of the web application by some other means) then this, along with the ability to process a file as a JSP, made remote code execution possible. It is important to note that mitigation is only required if an AJP port is accessible to untrusted users. Users wishing to take a defence-in-depth approach and block the vector that permits returning arbitrary files and execution as JSP may upgrade to Apache Tomcat 9.0.31, 8.5.51 or 7.0.100 or later. A number of changes were made to the default AJP Connector configuration in 9.0.31 to harden the default configuration. It is likely that users upgrading to 9.0.31, 8.5.51 or 7.0.100 or later will need to make small changes to their configurations. |
| FasterXML jackson-databind 2.x before 2.9.10.4 mishandles the interaction between serialization gadgets and typing, related to com.caucho.config.types.ResourceRef (aka caucho-quercus). |
| A vulnerability the Cisco Enterprise NFV Infrastructure Software (NFVIS) restricted CLI could allow an authenticated, local attacker with valid administrator-level credentials to elevate privileges and execute arbitrary commands on the underlying operating system as root. The vulnerability is due to insufficient restrictions during the execution of an affected CLI command. An attacker could exploit this vulnerability by leveraging the insufficient restrictions during the execution of an affected command. A successful exploit could allow the attacker to elevate privileges and execute arbitrary commands on the underlying operating system as root. |
| Microsoft Excel Security Feature Bypass Vulnerability |
| A denial of service vulnerability exists in the Windows implementation of Transport Layer Security (TLS) when it improperly handles certain key exchanges. An attacker who successfully exploited the vulnerability could cause a target system to stop responding.
To exploit this vulnerability, a remote unauthenticated attacker could send a specially crafted request to a target system utilizing TLS 1.2 or lower, triggering the system to automatically reboot.
The update addresses the vulnerability by changing the way TLS key exchange messages are validated. |
| Microsoft Exchange Server Remote Code Execution Vulnerability |
| When accepting a malicious intent from other installed apps, Firefox for Android accepted manifests from arbitrary file paths and allowed declaring webapp manifests for other origins. This could be used to gain fullscreen access for UI spoofing and could also lead to cross-origin attacks on targeted websites. *Note: This issue only affected Firefox for Android. Other operating systems are unaffected.*. This vulnerability affects Firefox < 83. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/msm/adreno: Fix a reference leak in a6xx_gpu_init()
In a6xx_gpu_init(), node is obtained via of_parse_phandle().
While there was a manual of_node_put() at the end of the
common path, several early error returns would bypass this call,
resulting in a reference leak.
Fix this by using the __free(device_node) cleanup handler to
release the reference when the variable goes out of scope.
Patchwork: https://patchwork.freedesktop.org/patch/700661/ |
| Improper access control in Azure API Management (APIM) allows an authorized attacker to execute code over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
net: bcmgenet: keep RBUF EEE/PM disabled
Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX
path on GENET hardware once MAC EEE becomes active. RX traffic stops
flowing while the link stays up and the usual descriptor/RX error
counters remain quiet. In that state the MAC still accepts frames
(rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to
DMA, so rx_packets is no longer incremented at the netdev level. On
some boards the corruption ends up as a paging fault in
skb_release_data via bcmgenet_rx_poll on an LPI exit.
Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian
Fainelli on an internal Broadcom 4908-family board with the same crash
signature. RBUF_PM_EN is not publicly documented.
This shows up more often now that phy_support_eee() enables EEE by
default, but it also affects older kernels as soon as TX LPI is
turned on via ethtool, so it is not specific to recent changes.
Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so
the bits stay off across resets. UMAC and TBUF setup is left alone so
TX-side EEE keeps working. |
| A malicious actor who lures an authenticated user to a malicious page could exploit a Cross-Origin Resource Sharing (CORS) misconfiguration found in UniFi OS to trigger actions in UniFi OS using that user's session. |
| In the Linux kernel, the following vulnerability has been resolved:
fuse-uring: end fuse_req on io-uring cancel task work
When io_uring delivers task work with tw.cancel set (PF_EXITING,
PF_KTHREAD fallback, or percpu_ref_is_dying on the ring context),
fuse_uring_send_in_task() takes the cancel branch, assigns
-ECANCELED, and falls through to fuse_uring_send(). That path only
flips the entry to FRRS_USERSPACE and completes the io_uring cmd;
it never discharges the ring entry's owning reference to the
fuse_req that fuse_uring_add_req_to_ring_ent() handed it at
dispatch time.
fuse_uring_send_in_task()
tw.cancel == true
err = -ECANCELED
fuse_uring_send(ent, cmd, err, issue_flags)
ent->state = FRRS_USERSPACE
list_move(&ent->list, &queue->ent_in_userspace)
ent->cmd = NULL
io_uring_cmd_done(-ECANCELED)
/* ent->fuse_req still set, req still hashed */
The fuse_req stays linked on fpq->processing[hash] and
fuse_request_end() is never invoked. The originating syscall
thread blocks in D-state in request_wait_answer() until
fuse_abort_conn() runs, which can be the entire connection
lifetime. For FR_BACKGROUND requests fc->num_background is never
decremented either, so repeated cancels inflate the counter until
max_background is hit and all later background ops stall. tw.cancel does
not imply a connection abort (e.g. a single io_uring worker thread exits
while the fuse connection stays up), so this cannot be left for
fuse_abort_conn() to clean up.
Ending the req but still routing the entry through fuse_uring_send()
is not enough: that leaves a req-less entry on ent_in_userspace, and
ent_list_request_expired() dereferences ent->fuse_req unconditionally
on the head of that list, which would then NULL-deref.
Fix the cancel branch to release the entry directly. Remove it from the
queue, complete the io_uring cmd, end the fuse_req, free the entry, and
drop its queue_refs (waking the teardown waiter if it was the last). |
| In the Linux kernel, the following vulnerability has been resolved:
mm/memory_hotplug: fix memory block reference leak on remove
Patch series "mm: Fix memory block leaks and locking", v2.
This series fixes two memory block device reference leaks and one locking
issue around the per-memory_block hwpoison counter.
This patch (of 2):
remove_memory_blocks_and_altmaps() looks up each memory block with
find_memory_block(), which acquires a reference to the memory block
device.
That reference is never dropped on this path, resulting in a leaked device
reference when removing memory blocks and their altmaps. Drop the
reference after retrieving mem->altmap and clearing mem->altmap, before
removing the memory block device. |
| A client-side enforcement of server-side security [CWE-602] vulnerability in Fortinet FortiManager version 7.4.0 and before 7.2.3 and FortiAnalyzer version 7.4.0 and before 7.2.3 may allow a remote attacker with low privileges to access a privileged web console via client side code execution. |
| A malicious actor with access to the network and under certain network configurations could exploit an Improper Access Control vulnerability found in certain devices running UniFi OS to make unauthorized changes to such UniFi OS devices. |
| A improper restriction of communication channel to intended endpoints vulnerability in Fortinet FortiSIEMWindowsAgent 7.4.0 through 7.4.1 may allow attacker to escalation of privilege via <insert attack vector here> |
| In the Linux kernel, the following vulnerability has been resolved:
drm/virtio: fix dma_fence refcount leak on error in virtio_gpu_dma_fence_wait()
dma_fence_unwrap_for_each() internally calls dma_fence_unwrap_first()
which does cursor->chain = dma_fence_get(head), taking an extra
reference. On normal loop completion, dma_fence_unwrap_next()
releases this via dma_fence_chain_walk() -> dma_fence_put().
When virtio_gpu_do_fence_wait() fails and the function returns early
from inside the loop, the cursor->chain reference is never released.
This is the only caller in the entire kernel that does an early return
inside dma_fence_unwrap_for_each.
Add dma_fence_put(itr.chain) before the early return. |
| Dell Server Hardware Manager, versions prior to 3.2.2, contains an Improper Access Control vulnerability. A low privileged attacker with local access could potentially exploit this vulnerability, leading to Elevation of privileges. |
