| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
cpufreq: imx6q: fix out-of-bounds write when probed more than once
imx6_soc_volt is allocated fresh on every probe, sized to the number of
ARM OPPs:
imx6_soc_volt = devm_kcalloc(cpu_dev, num, sizeof(*imx6_soc_volt),
GFP_KERNEL);
but it is filled through soc_opp_count, which has static storage and is
never reset. A second bind after an unbind keeps indexing from where the
first one stopped, and writes past the end of the new array.
Unbinding and rebinding the driver on qemu's mcimx6ul-evk, under KASAN:
BUG: KASAN: slab-out-of-bounds in imx6q_cpufreq_probe+0x3b0/0xa34
Write of size 4 at addr c5e90480 by task binder/73
imx6q_cpufreq_probe from platform_probe+0x88/0xe4
platform_probe from really_probe+0x108/0x384
bind_store from kernfs_fop_write_iter+0x1b4/0x28c
The write lands one u32 past the end of the allocation.
soc_opp_count is only read a few lines below the loop that fills it, so it
never needed static storage. Make it a local. |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: coreboot: Validate table bounds
The existing coreboot_table_populate() bounds checks limit individual
entries to the mapped length. However, coreboot_table_probe() replaces
the platform resource length with header and table sizes supplied by
firmware before mapping the full table.
A malformed table can overflow the 32-bit size addition or advertise an
extent beyond the resource, causing the driver to map and parse memory
outside the resource. A resource shorter than the fixed header is also
mapped as though it contained a complete header.
Reject resources shorter than the fixed header. After validating the
signature, require a complete header, calculate the advertised extent
with overflow checking, and reject extents beyond the resource before
remapping the table. |
| In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: avoid userspace overflow on invalid optlen
nfc_llcp_getsockopt() casts optval to (u32 __user *) for put_user(), so
the kernel always stores 4 bytes regardless of the caller-supplied
optlen. The existing min_t(u32, len, sizeof(u32)) only clamps the length
reported back to userspace; it does not constrain the store. A call with
optlen < 4 therefore writes past the user buffer, violating the
getsockopt(2) contract for all five supported optnames.
Reject any call with optlen < sizeof(u32) up front. 'len' is int, so a
plain size comparison would promote a negative optlen to size_t and slip
past the check; an explicit 'len < 0' test is added first to catch
negative values before the size compare. |
| IBM MQ for HPE NonStop 8.1.0 through 8.1.0.40 IBM MQ C client could allow a remote attacker to cause a denial of service or potentially execute arbitrary code due to improper validation of queue manager responses when requesting AMS policy data. |
| IBM MQ for HPE NonStop 8.1.0 through 8.1.0.40 could allow an authenticated attacker to obtain sensitive information or cause a denial of service due to improper validation of message header offset values. |
| IBM MQ for HPE NonStop 8.1.0 through 8.1.0.40 could allow an authenticated attacker to cause a denial of service or potentially execute arbitrary code during queue manager startup due to improper validation of cluster migration data. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: kyro: Validate overlay viewport coordinates
The overlay viewport end coordinates are computed from the viewport
origin and dimensions using 32-bit unsigned arithmetic. Large input
values can cause these calculations to wrap around before the resulting
coordinates are passed to SetOverlayViewPort().
SetOverlayViewPort() packs the viewport coordinates into 16-bit
register fields. The X coordinates are additionally adjusted by +2
and +1 before being written. Validate the coordinate calculations
for 32-bit wraparound and ensure that the adjusted coordinates fit
within their 16-bit register fields before calling
SetOverlayViewPort().
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/srp: fix heap information leak on a truncated SRP_CRED_REQ
srp_recv_done() passes wc->byte_len to srp_process_rsp(). It passes
nothing to srp_process_cred_req() and srp_process_aer_req(), which read
fixed-size fields from the receive buffer without checking that those
fields were received.
The buffer size is max_ti_iu_len, which comes from the login response
and is not validated. A target that advertises 8 and then sends an
8-byte SRP_CRED_REQ makes the initiator read req->tag from beyond the
end of the buffer. req->tag is copied into the SRP_CRED_RSP and sent
back, so those bytes reach the target. SRP_AER_REQ behaves the same way
and also reads req->lun.
The leak is 8 bytes per response. max_ti_iu_len also decides which slab
cache the buffer comes from. With 8 the buffer is a kmalloc-8 object and
the read is entirely outside it:
BUG: KASAN: slab-out-of-bounds in srp_recv_done+0x172b/0x1aa0
Read of size 8 at addr ffff888104714da8 by task kworker/u8:3/50
which belongs to the cache kmalloc-8 of size 8
The buggy address is located 0 bytes to the right of
allocated 8-byte region [ffff888104714da0, ffff888104714da8)
Without KASAN the returned bytes are whatever is next in the slab. One
run returned ".strtab".
rsp->data[3] in srp_process_rsp() has the same problem: only
resp_data_len is checked before it is read.
Drop a request that is shorter than the structure being parsed, and
check byte_len before the tsk_mgmt read. |
| Vulnerability in Drupal Gammu SMS Daemon. This issue affects Gammu SMS Daemon versions: *.*. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: zoned: don't force read-only on transient -EAGAIN from reloc merge
On a zoned FS, btrfs_delayed_refs_rsv_refill() returns -EAGAIN whenever
the over-committed metadata plus the zone_unusable bytes exceeds the
usable size in a metadata block-group to avoid heavy over-commit of
metadata and early ENOSPC in one transaction.
If this happens while doing reclaim, the transaction is getting aborted.
Treat -EAGAIN as a soft, retryable condition in case of block-group
reclaim. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: fix out-of-bounds link array access in mt7996_tx()
When mac80211 leaves the link unspecified, mt7996_tx() substitutes the
primary link id of the station or vif. That value is
IEEE80211_LINK_UNSPECIFIED (0xf) until the first link has been added,
and it is then used unchecked to index vif->link_conf[],
mvif->mt76.link[] and sta->link[], all of which hold
IEEE80211_MLD_MAX_NUM_LINKS (15) entries.
Clamp the primary link id to the default link before using it, and use
the clamped value for the link_sta fallback as well. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: reserve space for the CSA-abort countdown TLV
When a CSA countdown is active, mt7996_mcu_beacon_cntdwn() emits two
bss_bcn_cntdwn_tlv entries (the CSA countdown and the CCA-abort BCC), but
MT7996_BEACON_UPDATE_SIZE only reserved one. With MBSSID enabled and a
near-maximum beacon template the extra 8 bytes could push the offload
command past MT7996_MAX_BSS_OFFLOAD_SIZE and trigger skb_over_panic().
Reserve room for both countdown TLVs. |
| Vulnerability in Drupal Gammu SMS Daemon. This issue affects Gammu SMS Daemon versions: *.*. |
| Vulnerability in Drupal Gammu SMS Daemon. This issue affects Gammu SMS Daemon versions: *.*. |
| In the Linux kernel, the following vulnerability has been resolved:
powerpc/syscall: Fix syscall skip handling for seccomp and ptrace
After enabling GENERIC_ENTRY on PowerPC, syscall_enter_from_user_mode()
returns -1 as a sentinel to signal that seccomp or ptrace has intercepted
the syscall and already set a return value via syscall_set_return_value().
system_call_exception() was not handling this sentinel, and since -1UL
is >= NR_syscalls, the code fell into the out-of-range path and returned
-ENOSYS, overwriting the errno already placed in regs->gpr[3].
The naive fix of checking r0 == -1L before the NR_syscalls bounds check
is ambiguous: a user legitimately calling syscall(-1) also produces r0 ==
-1L, and a tracer intercepting such a call would have its injected return
value silently discarded.
Fix this by introducing a thread flag that is set whenever
syscall_set_return_value() explicitly updates the return value. In
system_call_exception(), check and clear this flag before dispatching
the syscall, and return the preset value directly when it is present.
This ensures that an explicitly supplied return value always suppresses
syscall execution, regardless of the syscall number.
This handles all seccomp actions correctly:
- SECCOMP_RET_ERRNO, SECCOMP_RET_TRACE (no tracer), SECCOMP_RET_USER_NOTIF:
all call syscall_set_return_value(), flag is set, injected value returned.
- SECCOMP_RET_TRAP, SECCOMP_RET_KILL: call syscall_rollback() and deliver
a signal; flag is not set, but the process is dying so the return value
is irrelevant.
The fix covers both ppc32 and ppc64 with no #ifdefs. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: fix out-of-bounds access in mmio copy helpers
mt76_mmio_write_copy() and mt76_mmio_read_copy() iterate up to
ALIGN(len, 4), so a length that is not a multiple of four reads past the
source buffer (write_copy) or writes past the destination (read_copy).
Copy the aligned body in the loop and handle the remaining tail through a
4-byte bounce buffer, keeping the register access width unchanged. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: avoid nss underflow in mt7915_mcu_get_sta_nss
If a peer's VHT/HE MCS map has no supported spatial stream (all fields
0x3), the loop exits with nss == 0 and the function returned (u8)-1 (255),
which was then written into the firmware sta_rec_bf beamforming fields.
Clamp the result to 0. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: ufs: debugfs: Reserve space for a string terminator
ufs_saved_err_write() copies user input into a zero-initialized stack
buffer and passes it to kstrtoint(). A write that fills the entire buffer
overwrites its only terminator.
Reject an input whose length leaves no room for the trailing NUL. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: Avoid buffer overread in ath12k_wmi_op_rx()
Currently, in ath12k_wmi_op_rx(), the firmware buffer is read without
first verifying that the buffer has enough data to hold a header. This
could result in a buffer overread.
Update the logic to verify the buffer contains at least enough data to
hold a wmi_cmd_hdr before reading from the buffer.
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.1.c7-00108-QCAHMTSWPL_V1.0_V2.0_SILICONZ_UPSTREAM-3 |
| In the Linux kernel, the following vulnerability has been resolved:
gpu: host1x: Avoid stack over-read in debug output helpers
host1x_debug_output() and host1x_debug_cont() used vsnprintf(), which
returns the length the formatted string would have reached with an
unbounded buffer. That return value was passed straight to o->fn as
the number of bytes to emit.
This could cause a read past end of the output buffer if a call to
host1x_debug_* produced a string longer than 256 bytes. This only
affected the debugfs files as the printk debug sink ignores the
number of bytes. In practice, this is very unlikely to occur.
Fix by switching to vscnprintf(), which returns the number of bytes
actually written. |
