| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: validate index block header more strictly
Modify ntfs_index_block_inconsisent() to perform stricter validation of
INDEX_HEADER geometry in INDX blocks, and update
ntfs_lookup_inode_by_name() to use that function to validate INDX
blocks. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: validate attribute values on lookup
ntfs_attr_find() and ntfs_external_attr_find() check that generic
resident attribute values fit in their attribute records and that
fixed-size resident values are large enough. For variable-length resident
formats, however, the fixed part is not enough: embedded length fields
can still point callers past the resident value.
A crafted image can set a small resident $FILE_NAME value_length while
leaving file_name_length large. Callers then trust file_name_length and
read past the resident value when converting or comparing the name. This
was reproduced with a crafted image under KASAN as a slab-out-of-bounds
read from the kmalloc-1k MFT record copy. The stack included
ntfs_lookup(), ntfs_iget(), ntfs_read_locked_inode(), ntfs_attr_name_get(),
ntfs_ucstonls(), and utf16s_to_utf8s().
Add a shared attribute value validator and use it before a lookup path
can return an attribute, including the AT_UNUSED enumeration case where
callers inspect returned attributes directly. The helper validates
resident value bounds, minimum resident value sizes, variable-length
$FILE_NAME fields, and non-resident mapping-pairs metadata that was
previously checked separately in both lookup paths.
This also preserves the intended resident @val matching semantics in the
external attribute lookup path. The old duplicated validation block
overwrote the actual resident value length with the type-specific minimum
length before comparing @val, so variable-length resident values could
fail to match even when the bytes were identical. Keep the comparison on
the actual value length, and make ntfs_attrlist_entry_add() compare
resident attributes with lowest_vcn zero instead of reading the
non-resident union member after a successful resident match.
Reject non-resident $FILE_NAME records too: the format requires
$FILE_NAME to be resident and callers treat returned records as resident. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: fix off-by-one in mapping pairs decoding bounds checks
In ntfs_mapping_pairs_decompress(), attr_end points one byte past the
end of the attribute record:
attr_end = (u8 *)attr + le32_to_cpu(attr->length);
The two bounds checks validating that mapping pair data bytes fit within
the attribute use strict greater-than (>), which allows a one-byte
out-of-bounds read when the data extends exactly to attr_end:
b = *buf & 0xf;
if (b) {
if (unlikely(buf + b > attr_end)) // off-by-one
goto io_error;
for (deltaxcn = (s8)buf[b--]; b; b--)
deltaxcn = (deltaxcn << 8) + buf[b];
}
When buf + b == attr_end, the check evaluates to false and buf[b] reads
one byte past the valid attribute boundary. The same pattern appears in
the LCN delta bytes check.
Fix both checks to use >= so that buf[b] at exactly attr_end is
correctly rejected as out of bounds. |
| A vulnerability was found in lwIP up to 2.2.1. Affected is the function snmp_parse_inbound_frame of the file src/apps/snmp/snmp_msg.c of the component snmpv3 USM Handler. Performing a manipulation of the argument msgAuthenticationParameters results in stack-based buffer overflow. The attack may be initiated remotely. The patch is named 0c957ec03054eb6c8205e9c9d1d05d90ada3898c. It is suggested to install a patch to address this issue. Two separate issue reports were submitted to the project. Their processing was merged as a duplicate. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: mcast: avoid OOB read of num_dests header
Before the access to struct batadv_tvlv_mcast_tracker's num_dests, it is
attempted to check whether enough space is actually in the network header.
But instead of using offsetofend() to check for the whole size (2) which
must be accessible, offsetof() of is called. The latter is always returning
0. The comparison with the network header length will always return that
enough data is available - even when only 1 or 0 bytes are accessible.
Instead of using offsetofend(), use the more common check for the whole
header. |
| In the Linux kernel, the following vulnerability has been resolved:
leds: uleds: Fix potential buffer overread
The name string supplied by userspace is not guaranteed to be
null-terminated, so using strchr() on it might result in a buffer
overread. The same thing will happen when said string is used by
the LED class device.
Fix this by using strnchr() instead and explicitly check that
the name string is properly null-terminated. |
| In the Linux kernel, the following vulnerability has been resolved:
LoongArch: KVM: Check irq validity in kvm_vcpu_ioctl_interrupt()
Function kvm_vcpu_ioctl_interrupt() can be called from userspace, here
add irq validility cheking in kvm_vcpu_ioctl_interrupt(). |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe/pf: Don't attempt to process FAST_REQ or EVENT relays
Currently defined VF/PF relay actions use regular REQUEST messages
only and the PF shouldn't attempt to handle FAST_REQUEST nor EVENT
messages as this would result in breaking the VFPF ABI protocol
and also might trigger an assert on the PF side.
(cherry picked from commit 1714d360fc5ae2e0886a69e979095d9c7ff3568a) |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: Validate iph->ihl in nf_flow_ip4_tunnel_proto()
Add sanity check for iph->ihl field in nf_flow_ip4_tunnel_proto() before
using it to compute the header size, avoiding out-of-bounds access with
malformed IP headers.
While at it, use iph->protocol instead of the hardcoded IPPROTO_IPIP
constant when setting ctx->tun.proto and reference ctx->tun.hdr_size
when updating ctx->offset. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: qcom: reject stream disable with no active interface
handle_uaudio_stream_req() resolves an interface index with
info_idx_from_ifnum(), which returns -EINVAL when no interface matches.
The enable branch and the response: cleanup label both guard against a
negative index, but the disable branch does not: it forms
info = &uadev[pcm_card_num].info[info_idx] and dereferences it.
uadev[].info is a pointer allocated only when a stream is first enabled,
so a negative info_idx on the disable path is unsafe in two ways:
- If the card was never enabled, .info is NULL and &info[-EINVAL] is a
wild pointer; reading info->data_ep_pipe faults (kernel oops).
- If the card was enabled at least once (.info allocated) and the
disable names an interface that does not match, &info[-EINVAL] points
before the allocation; info->data_ep_pipe / info->sync_ep_pipe are an
out-of-bounds slab read and, when non-zero, an out-of-bounds 4-byte
write (both pipe fields are cleared to 0). That is memory corruption,
not just a NULL dereference.
The request is reachable from unprivileged local userspace over
AF_QIPCRTR. Reject a disable request with no resolved interface, matching
the guard the enable path already has. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: xilinx-ams: fix out-of-bounds channel lookup in event handling
ams_event_to_channel() may return a pointer past the end of
dev->channels when no matching scan_index is found. This can lead
to invalid memory access in ams_handle_event().
Add a bounds check in ams_event_to_channel() and return NULL when
no channel is found. Also guard the caller to safely handle this
case. |
| In the Linux kernel, the following vulnerability has been resolved:
can: peak_usb: add bounds check for USB channel index
The channel control index ctrl_idx is derived from rx->len which comes
directly from a device USB payload. The mask 0x0f allows values 0-15, but
the array size of usb_if->dev[] is only 2. Values 2-15 cause heap
out-of-bounds read, eventually causing kernel panic in the IRQ context.
Add bounds checking for ctrl_idx before the array access in both
pcan_usb_pro_handle_canmsg() and pcan_usb_pro_handle_error(). |
| In the Linux kernel, the following vulnerability has been resolved:
cxl/region: Fix out-of-bounds access in cxl_cancel_auto_attach()
In cxl_cancel_auto_attach(), it assumes cxled->pos is a valid index for
accessing p->targets[]. However, cxled->pos can be set to negative errno
in cxl_region_sort_targets() if cxl_calc_interleave_pos() fails. This
causes the driver to use a negative index to access p->targets[],
resulting in out-of-bounds access.
Fix it by walking p->targets[] instead of using cxled->pos directly. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: marvell/octeontx - fix DMA cleanup using wrong loop index
The sg_cleanup path used list[i] instead of list[j] when unmapping DMA
buffers, leaking successfully mapped entries and repeatedly unmapping
the failed one. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: codecs: hdac_hdmi: Validate written enum value
hdac_hdmi_set_pin_port_mux() uses the written enum value to index the
texts array before calling snd_soc_dapm_put_enum_double(), which validates
that the value is within the enum item range.
An out-of-range value can therefore make the driver read past the texts
array before the helper rejects the write. Move the lookup after the helper
has accepted the value. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: tegra: tegra210_ahub: Validate written enum value
tegra_ahub_put_value_enum() reads e->values[item[0]] before
checking whether item[0] is within the enum item range. The existing
check therefore happens too late to prevent an out-of-range read of the
values array.
Move the check before the array access. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/irdma: Fix OOB read during CQ MR registration
Sashiko pointed out an unrelated bug during a previous patch:
https://sashiko.dev/#/patchset/20260512183852.614045-1-jmoroni%40google.com
This change fixes the bug by eliminating the cqmr->split field which
was not being set properly and instead just checks the CQ resize
feature flag directly.
The cqmr->split field essentially tracks whether IRDMA_FEATURE_CQ_RESIZE
is set, but it was not being set until CQ creation time, which is _after_
CQ memory registration (the only other place where it is referenced).
As a result, it would always be false during MR registration and would
therefore cause irdma_handle_q_mem to populate cqmr->shadow even for GEN_2
HW and beyond:
cqmr->shadow = (dma_addr_t)arr[req->cq_pages];
The issue is that for GEN_2 and beyond, req->cq_pages may be exactly equal
to iwmr->page_cnt and therefore equal to the size of arr, which would cause
an OOB read by one. |
| In the Linux kernel, the following vulnerability has been resolved:
nvme: fix FDP fdpcidx bounds check
The fdpcidx bounds check sets n = NUMFDPC + 1 but used > instead of >=,
incorrectly accepting fdp_idx when it equals n (i.e. NUMFDPC + 1). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: sm501fb: Fix buffer errors in OF binding code
The code that gets the frame buffer mode from OF has 'use after free',
'buffer overrun' and memory leaks.
info->edid_data isn't free if the probe functions fail or if
pd->def_mode is set.
If both the CRT and PANEL are enabled info->edid_data is used after
being freed and is freed twice.
The string returned by of_get_property(np, "mode", &len) is just
written over either the static "640x480-16@60" or the module parameter
string without any regard for the length (which is most likely longer).
Use kstrump() for the OF mode and free everything before freeing 'info. |
| In the Linux kernel, the following vulnerability has been resolved:
evm: terminate and bound the evm_xattrs read buffer
evm_read_xattrs() allocates size + 1 bytes, fills them from the list of
enabled xattrs, and then passes strlen(temp) to
simple_read_from_buffer(). When no configured xattrs are enabled, the
fill loop stores nothing and temp[0] remains uninitialized, so strlen()
reads beyond initialized memory.
Explicitly terminate the buffer after allocation, use snprintf() for
each formatted line, and pass the accumulated length, without risk of
truncation, to simple_read_from_buffer(). |
