| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Pydantic AI is a Python agent framework for building applications and workflows with Generative AI. From 2.10.0 until 2.53.0, streamed requests made through ConcurrencyLimitedModel or limit_model_concurrency can retain shared concurrency slots because anyio.CapacityLimiter associates an acquired slot with the borrowing task while streaming cleanup can run in a different task. Early stream termination, cancellation, consumer exceptions, or complete stream_text() consumption with debounce_by=0.1 can therefore leave capacity occupied, eventually preventing later requests that share the long-lived limiter from proceeding and causing a denial of service. Agent-level max_concurrency and non-streaming model requests are not affected. This issue is fixed in version 2.53.0. |
| In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: fix dma mapping leak in stmmac_tso_xmit()
In stmmac_tso_xmit(), if the DMA mapping of an skb fragment fails, the
frame is dropped but the DMA mappings already created for the linear
part and for the fragments mapped before the failure are never
unmapped, leaking DMA mappings.
Fix the leak by walking back over the descriptors used by the frame and
releasing each of them with stmmac_free_tx_buffer(). Moreover, release
the descriptors with stmmac_release_tx_desc() unmapping the DMA buffers. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: core: Run queues for all non-SDEV_DEL devices from scsi_run_host_queues
While a SCSI host is in a recovery state, scsi_mq_requeue_cmd() will not
set the requeue list for a requeued command to be kicked in the future.
The expectation is a call to scsi_run_host_queues() will kick all SCSI
devices once the recovery state is cleared.
However, scsi_run_host_queues() uses shost_for_each_device() which uses
scsi_device_get() and so will ignore devices in a partially removed
state like SDEV_CANCEL. But these devices may also have requeued
requests, leaving their requests stuck from not being kicked and causing
the removal process of the device to hang.
scsi_run_host_queues() needs to run against more devices than the macro
shost_for_each_device() allows. Instead of using the too limiting
scsi_device_get() state checks, only ignore devices in SDEV_DEL state or
when unable to acquire a reference. Attempt to run the queues for all
other devices when scsi_run_host_queues() is called. |
| In the Linux kernel, the following vulnerability has been resolved:
ethtool: rss: fix indir_table and hkey leak on get_rxfh failure
rss_prepare_get() allocates the indirection table and hash key buffer
via rss_get_data_alloc(), then calls ops->get_rxfh() to populate them.
If get_rxfh() fails, the function returns an error without freeing
the allocation. |
| A flaw was found in SSSD. An issue in the Kerberos Credential Manager (KCM) responder allows a local user to cause a Denial of Service (DoS) by maintaining a persistent connection and repeatedly storing and destroying credentials. Because the service fails to release cached objects from memory when credentials are removed, memory consumption grows continuously, ultimately exhausting available memory and rendering the service unresponsive. |
| IEEE C37.118 Synchrophasor protocol dissector memory leak in 4.6.0 to 4.6.8 and 4.4.0 to 4.4.18 allows denial of service |
| improper handling of exceptional conditions, Missing release of resource after effective lifetime vulnerability in Apache Thrift java bindings.
This issue affects Apache Thrift: before 0.25.0.
Users are recommended to upgrade to version 0.25.0, which fixes the issue. |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to 7.1.2-31, a crafted Magick script can cause an opened file pointer to remain unclosed, allowing repeated processing to exhaust available file descriptors. This issue is fixed in version 7.1.2-31. |
| ASP.NET Core Denial of Service Vulnerability |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix smbd_connection leak on cifs_get_tcp_session() error
When an RDMA connection is successfully established via
smbd_get_connection() but cifs_get_tcp_session() later fails (e.g.
kthread_create() returns an error), the error path frees tcp_ses
without first destroying the smbd_connection.
Fix this by calling smbd_destroy() in the out_err cleanup path before
kfree(tcp_ses). smbd_destroy() safely handles the case where
smbd_conn is NULL, so it can be called unconditionally. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/mad: Fix receive buffer leak when PKey enforcement fails
ib_mad_complete_recv() initializes mad_recv_wc->rmpp_list and then runs
ib_mad_enforce_security() before linking recv_buf onto that list. On
failure it calls ib_free_recv_mad(), which only walks rmpp_list and frees
the ib_mad_private of every buffer found there. As the list is still
empty at that point, nothing is freed at all.
The caller cannot clean up either: ib_mad_recv_done() sets recv to NULL
right after ib_mad_complete_recv() returns, assuming the MAD layer took
ownership of the buffer. Every MAD that fails the PKey check therefore
leaks one ib_mad_private (about 300 bytes per IB port MAD, ~2K for OPA),
and a remote node can trigger this repeatedly by sending MADs with a
wrong PKey.
Link recv_buf onto rmpp_list right after the list is initialized, so the
error path has something to free. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: mesh: release the channel if start fails
ieee80211_join_mesh() acquires a channel context and then calls
ieee80211_start_mesh(), which can fail. In that case, the chanctx
isn't released then interface removal will attempt to unassign it
after it's removed from the driver, hitting:
wlan0: Failed check-sdata-in-driver check, flags: 0x0
WARNING: net/mac80211/driver-ops.c:366 at drv_unassign_vif_chanctx
ieee80211_assign_link_chanctx
__ieee80211_link_release_channel
ieee80211_link_release_channel
ieee80211_teardown_sdata
unregister_netdevice_many_notify
_cfg80211_unregister_wdev
ieee80211_remove_interfaces
ieee80211_unregister_hw
mac80211_hwsim_del_radio
hwsim_exit_net
Correctly release the channel on start failures. |
| In the Linux kernel, the following vulnerability has been resolved:
phy: fsl-imx8mq-usb: fix typec switch leak on probe error path
If probe fails after imx95_usb_phy_get_tca() succeeds, the typec
switch leaks because the only cleanup path was in .remove(), which
never runs on probe failure.
Use devm_add_action_or_reset() so the switch is cleaned up on both
probe failure and driver removal. The imx95_usb_phy_put_tca() is no
longer needed, it will be removed in .remove() too. |
| In the Linux kernel, the following vulnerability has been resolved:
mmc: sdhci-of-aspeed: Remove children before releasing SDC resources
Probe failure and removal leave SDHCI child devices registered after the
parent clock and managed resources are released.
Unregister the OF children in reverse order before disabling the parent
clock on both paths. Use of_platform_device_destroy() because manual
child creation does not set the flag required by of_platform_depopulate().
This issue was identified during our ongoing static-analysis research
while reviewing kernel code. |
| In the Linux kernel, the following vulnerability has been resolved:
af_unix: Unify scc_index when finalising SCC in __unix_walk_scc().
Commit bfdb01283ee8 ("af_unix: Assign a unique index to SCC.")
changed Tarjan's algorithm to update lowlink with lowlink,
which is called lowpoint (unix_vertex.scc_index).
unix_vertex_dead() assumes all vertices in an SCC share the same
lowpoint, but this is not always true if an SCC has two or more
back edges, depending on the order of DFS.
For example, the graph below has two back edges from B to A
and from C to B.
A --> B --> C
^ | ^ |
`----' `----'
If DFS walks through A -> B -> C -> B (-> C -> B) -> A (-> B -> A),
each index and scc_index will be updated as follows.
A --> B --> C C = (3, 3) (index, scc_index)
B = (2, 2)
A = (1, 1)
A ... B ... C C = (3, 2)<-.
^ | B = (2, 2) -'
`----' A = (1, 1)
A ... B ... C C = (3, 2)
^ | . . B = (2, 1)<-.
`----' .... A = (1, 1) -'
Then, unix_vertex_dead() thinks that B is passed to another
SCC with scc_index 2, and the SCC is not garbage-collected.
This does not happen if DFS walks in a different order below
or starts from B.
1 3
A --> B --> C
^ | ^ |
`----' `----'
2 4
Let's unify scc_index across the SCC when finalising it.
Note that updating v->index was previously done in unix_scc_dead(),
when called from __unix_walk_scc(), just to save one loop. Since
__unix_walk_scc() now iterates over the SCC anyway, the update is
moved back to __unix_walk_scc() and 'fast' argument is dropped. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/rtrs-clt: Fix CQ pool leak when connect is interrupted
The client borrows shared CQ credits in the ADDR_RESOLVED handler via
ib_cq_pool_get(), before the peer is connected. create_cm() can return
-ERESTARTSYS from wait_event_interruptible_timeout() without destroying
the CM ID. The init_conns() and stop-and-destroy paths then call
destroy_con_cq_qp() while cq is still NULL (no PUT) and only afterwards
rdma_destroy_id().
CMA serializes the handler against rdma_destroy_id() with handler_mutex,
but that does not order the GET against destroy_con_cq_qp(). If
ADDR_RESOLVED has already passed the DESTROYING check, it can take
con_mutex, GET credits, and then lose the con to kfree. Device
unregister later hits WARN_ON(cq->cqe_used) in ib_cq_pool_cleanup().
Set a per-connection flag under con_mutex before CQ/QP teardown so a
racing ADDR_RESOLVED cannot borrow credits after teardown has begun. |
| In the Linux kernel, the following vulnerability has been resolved:
net/packet: clear RX owner on VNET header error
Commit 61fad6816fc1 ("net/packet: tpacket_rcv: avoid a producer race
condition") added rx_owner_map and made tpacket_rcv() claim a V1 or V2
ring slot before converting the virtio-net header. If the conversion
fails, the drop path leaves the slot claimed.
With a one-frame TPACKET_V2 ring, an unsupported UDP GSO packet leaves
the only slot unavailable, so the ring also drops the next valid packet.
Clear the ownership bit on this error path. TPACKET_V3 already clears
its block state here. |
| A flaw was found in SSSD. In configurations where the autofs responder service is enabled, memory allocated during successful request processing is not released until the client connection terminates. A local attacker can exploit this vulnerability by maintaining an open connection and repeatedly submitting valid requests, leading to memory exhaustion and a Denial of Service (DoS). |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix the possible bioc_list memory leak during error
There are two possible ways to leak bioc memory on
btrfs_ordered_extent::bioc_list:
- An error occurred for btrfs_insert_one_raid_extent()
Then the function btrfs_insert_raid_extent() immediately return
without freeing any bioc in the bioc_list.
- An ordered extent hit an IO error
In that case the ordered extent will have BTRFS_ORDERED_IOERR set, and
skip the call on btrfs_insert_raid_extent() completely.
Fix the problem by:
- Introduce a new helper, btrfs_cleanup_ordered_bioc_list()
Which will remove all bioc from the bioc_list, and release the bioc.
- Call the above helper for btrfs_insert_raid_extent()
So that the cleanup helper is always called no matter what.
- Call the above helper for btrfs_finish_one_ordered()
This is called just before the final release on the ordered extent.
This was reported by Sashiko when reviewing another patch. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: amd: yc: fix memory leak in acp6x_pdm_dma_close()
acp6x_pdm_dma_close() does not free the runtime->private_data buffer
allocated in acp6x_pdm_dma_open(). Add the missing kfree. |
