| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
w1: ds28e17: reject an oversize length on an I2C block read
w1_f19_i2c_master_transfer() is the master_xfer for the DS28E17 1-Wire
to I2C bridge. On an I2C_M_RECV_LEN read, it takes the length from the
device. The downstream slave puts a length byte in buf[0]. The driver
then reads that many bytes into buf[1] with w1_f19_i2c_read().
buf[0] is controlled by the device and can be 0 to 255.
w1_f19_i2c_read() only rejects a zero count. The caller buffer is
I2C_SMBUS_BLOCK_MAX + 2, so 34 bytes. A length above 32 makes the read
run past it, up to about 222 bytes out of bounds.
The SMBus core does check buf[0] against I2C_SMBUS_BLOCK_MAX. That
check runs after master_xfer returns. By then the write is already
done. i2c-algo-bit rejects an oversize length before it copies, and
returns -EPROTO.
Reject a length above I2C_SMBUS_BLOCK_MAX at both RECV_LEN sites, the
same way i2c-algo-bit does. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: fix BPF_PROG_QUERY OOB write and cgroup backward compat
BPF_PROG_QUERY writes back the 'query.revision' field unconditionally to
userspace. If userspace passes a smaller 'bpf_attr' structure (e.g. 40
bytes, which was the layout before the addition of 'query.revision'),
the kernel performs an out-of-bounds write.
Fix this by propagating the user-provided attribute size 'uattr_size'
down to the cgroup query handlers, and conditionally skipping writing
the revision field to userspace when the provided buffer size is
insufficient.
query.revision in bpf_mprog_query is structurally identical to the
cgroup case: a late tail field, written unconditionally.
But the backward-compat hazard is not the same.
The min-historical-size test is per command, and bpf_mprog_query only
serves attach types that were born with revision in the struct:
- tcx_prog_query -> BPF_TCX_INGRESS/EGRESS
- netkit_prog_query -> BPF_NETKIT_PRIMARY/PEER
tcx, netkit, the revision field, and bpf_mprog_query itself all landed in
the same v6.6 merge window (053c8e1f235d added the mprog query API +
revision; tcx in e420bed02507, netkit in 35dfaad7188c). There has never
been a tcx/netkit BPF_PROG_QUERY userspace that doesn't know about
revision. So for these commands the minimum legitimate struct already
covers offset 56-64 — no old binary can be broken here.
Contrast with cgroup: BPF_PROG_QUERY on cgroup attach types shipped in
2017; revision write-back was bolted on years later (120933984460). That
path has a real population of pre-revision callers. |
| In the Linux kernel, the following vulnerability has been resolved:
netfs: Fix netfs_read_folio() to wait on writeback
Fix netfs_read_folio() to wait for an ongoing writeback to complete so that
it can trust the dirty flag and whatever is attached to folio->private
(folio->private may get cleaned up by the collector before it clears the
writeback flag). |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: cdc_ncm: add ndpoffset to NDP16 nframes bounds check
cdc_ncm_rx_verify_ndp16() validates that the NDP header and its DPE
entries fit within the skb. The first check correctly accounts for
ndpoffset:
if ((ndpoffset + sizeof(struct usb_cdc_ncm_ndp16)) > skb_in->len)
but the second check omits it:
if ((sizeof(struct usb_cdc_ncm_ndp16) +
ret * (sizeof(struct usb_cdc_ncm_dpe16))) > skb_in->len)
This validates the DPE array size against the total skb length as if
the NDP were at offset 0, rather than at ndpoffset. When the NDP is
placed near the end of the NTB (large wNdpIndex), the DPE entries can
extend past the skb data buffer even though the check passes.
cdc_ncm_rx_fixup() then reads out-of-bounds memory when iterating
the DPE array.
Add ndpoffset to the nframes bounds check and use struct_size_t() to
express the NDP-plus-DPE-array size more clearly. |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: cdc_ncm: add ndpoffset to NDP32 nframes bounds check
The same bounds-check bug fixed for NDP16 in the previous patch also
exists in cdc_ncm_rx_verify_ndp32(). The DPE array size is validated
against the total skb length without accounting for ndpoffset, allowing
out-of-bounds reads when the NDP32 is placed near the end of the NTB.
Add ndpoffset to the nframes bounds check and use struct_size_t() to
express the NDP-plus-DPE-array size more clearly.
Compile-tested only. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: fix overflow in dacloffset bounds check
The dacloffset field was originally typed as int and used in an
unchecked addition, which could overflow and bypass the existing
bounds check in both smb_check_perm_dacl() and smb_inherit_dacl().
This could result in out-of-bounds memory access and a kernel crash
when dereferencing the DACL pointer.
This patch converts dacloffset to unsigned int and uses
check_add_overflow() to validate access to the DACL. |
| A security flaw has been discovered in Tenda W20E 15.11.0.61068_1546_841_CN_TDC. Impacted is the function formDelWebAuthWhiteUser. Performing a manipulation of the argument webAuthWhiteUserIndex results in stack-based buffer overflow. The attack can be initiated remotely. |
| Heap-based buffer overflow in Microsoft Office allows an unauthorized attacker to execute code over a network. |
| Stack-based buffer overflow in Microsoft Office Word allows an unauthorized attacker to execute code over a network. |
| Buffer over-read in Microsoft Office Word allows an unauthorized attacker to disclose information over a network. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Error Reporting allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges over a network. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Biometric Service allows an authorized attacker to elevate privileges locally. |
