| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
powerpc/pseries/iommu: LPAR panics during boot up with a frozen PE
At the time of LPAR boot up, partition firmware provides Open Firmware
property ibm,dma-window for the PE. This property is provided on the PCI
bus the PE is attached to.
There are execptions where the partition firmware might not provide this
property for the PE at the time of LPAR boot up. One of the scenario is
where the firmware has frozen the PE due to some error condition. This
PE is frozen for 24 hours or unless the whole system is reinitialized.
Within this time frame, if the LPAR is booted, the frozen PE will be
presented to the LPAR but ibm,dma-window property could be missing.
Today, under these circumstances, the LPAR oopses with NULL pointer
dereference, when configuring the PCI bus the PE is attached to.
BUG: Kernel NULL pointer dereference on read at 0x000000c8
Faulting instruction address: 0xc0000000001024c0
Oops: Kernel access of bad area, sig: 7 [#1]
LE PAGE_SIZE=64K MMU=Radix SMP NR_CPUS=2048 NUMA pSeries
Modules linked in:
Supported: Yes
CPU: 0 PID: 1 Comm: swapper/0 Not tainted 6.4.0-150600.9-default #1
Hardware name: IBM,9043-MRX POWER10 (raw) 0x800200 0xf000006 of:IBM,FW1060.00 (NM1060_023) hv:phyp pSeries
NIP: c0000000001024c0 LR: c0000000001024b0 CTR: c000000000102450
REGS: c0000000037db5c0 TRAP: 0300 Not tainted (6.4.0-150600.9-default)
MSR: 8000000002009033 <SF,VEC,EE,ME,IR,DR,RI,LE> CR: 28000822 XER: 00000000
CFAR: c00000000010254c DAR: 00000000000000c8 DSISR: 00080000 IRQMASK: 0
...
NIP [c0000000001024c0] pci_dma_bus_setup_pSeriesLP+0x70/0x2a0
LR [c0000000001024b0] pci_dma_bus_setup_pSeriesLP+0x60/0x2a0
Call Trace:
pci_dma_bus_setup_pSeriesLP+0x60/0x2a0 (unreliable)
pcibios_setup_bus_self+0x1c0/0x370
__of_scan_bus+0x2f8/0x330
pcibios_scan_phb+0x280/0x3d0
pcibios_init+0x88/0x12c
do_one_initcall+0x60/0x320
kernel_init_freeable+0x344/0x3e4
kernel_init+0x34/0x1d0
ret_from_kernel_user_thread+0x14/0x1c |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: act_skbmod: Skip non-Ethernet packets
Currently tcf_skbmod_act() assumes that packets use Ethernet as their L2
protocol, which is not always the case. As an example, for CAN devices:
$ ip link add dev vcan0 type vcan
$ ip link set up vcan0
$ tc qdisc add dev vcan0 root handle 1: htb
$ tc filter add dev vcan0 parent 1: protocol ip prio 10 \
matchall action skbmod swap mac
Doing the above silently corrupts all the packets. Do not perform skbmod
actions for non-Ethernet packets. |
| usb_8dev_start_xmit in drivers/net/can/usb/usb_8dev.c in the Linux kernel through 5.17.1 has a double free. |
| An issue was discovered in the Linux kernel before 6.3.2. A use-after-free was found in dm1105_remove in drivers/media/pci/dm1105/dm1105.c. |
| An issue was discovered in the Linux kernel before 6.3.2. A use-after-free was found in saa7134_finidev in drivers/media/pci/saa7134/saa7134-core.c. |
| The Linux kernel before 6.2.9 has a race condition and resultant use-after-free in drivers/net/ethernet/qualcomm/emac/emac.c if a physically proximate attacker unplugs an emac based device. |
| A vulnerability was found in compare_netdev_and_ip in drivers/infiniband/core/cma.c in RDMA in the Linux Kernel. The improper cleanup results in out-of-boundary read, where a local user can utilize this problem to crash the system or escalation of privilege. |
| A flaw was found in the Linux kernel's udmabuf device driver. The specific flaw exists within a fault handler. The issue results from the lack of proper validation of user-supplied data, which can result in a memory access past the end of an array. An attacker can leverage this vulnerability to escalate privileges and execute arbitrary code in the context of the kernel. |
| In the Linux kernel through 6.2.8, net/bluetooth/hci_sync.c allows out-of-bounds access because amp_init1[] and amp_init2[] are supposed to have an intentionally invalid element, but do not. |
| An issue was discovered in the Linux kernel before 5.13.3. lib/seq_buf.c has a seq_buf_putmem_hex buffer overflow. |
| do_tls_getsockopt in net/tls/tls_main.c in the Linux kernel through 6.2.6 lacks a lock_sock call, leading to a race condition (with a resultant use-after-free or NULL pointer dereference). |
| An issue was discovered the x86 KVM subsystem in the Linux kernel before 5.18.17. Unprivileged guest users can compromise the guest kernel because TLB flush operations are mishandled in certain KVM_VCPU_PREEMPTED situations. |
| In drivers/char/virtio_console.c in the Linux kernel before 5.13.4, data corruption or loss can be triggered by an untrusted device that supplies a buf->len value exceeding the buffer size. NOTE: the vendor indicates that the cited data corruption is not a vulnerability in any existing use case; the length validation was added solely for robustness in the face of anomalous host OS behavior |
| In the Linux kernel, the following vulnerability has been resolved:
tpm: Lock TPM chip in tpm_pm_suspend() first
Setting TPM_CHIP_FLAG_SUSPENDED in the end of tpm_pm_suspend() can be racy
according, as this leaves window for tpm_hwrng_read() to be called while
the operation is in progress. The recent bug report gives also evidence of
this behaviour.
Aadress this by locking the TPM chip before checking any chip->flags both
in tpm_pm_suspend() and tpm_hwrng_read(). Move TPM_CHIP_FLAG_SUSPENDED
check inside tpm_get_random() so that it will be always checked only when
the lock is reserved. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: TAS2781: Fix tasdev_load_calibrated_data()
This function has a reversed if statement so it's either a no-op or it
leads to a NULL dereference. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: Check socket flag instead of hcon
This fixes the following Smatch static checker warning:
net/bluetooth/iso.c:1364 iso_sock_recvmsg()
error: we previously assumed 'pi->conn->hcon' could be null (line 1359)
net/bluetooth/iso.c
1347 static int iso_sock_recvmsg(struct socket *sock, struct msghdr *msg,
1348 size_t len, int flags)
1349 {
1350 struct sock *sk = sock->sk;
1351 struct iso_pinfo *pi = iso_pi(sk);
1352
1353 BT_DBG("sk %p", sk);
1354
1355 if (test_and_clear_bit(BT_SK_DEFER_SETUP,
&bt_sk(sk)->flags)) {
1356 lock_sock(sk);
1357 switch (sk->sk_state) {
1358 case BT_CONNECT2:
1359 if (pi->conn->hcon &&
^^^^^^^^^^^^^^ If ->hcon is NULL
1360 test_bit(HCI_CONN_PA_SYNC,
&pi->conn->hcon->flags)) {
1361 iso_conn_big_sync(sk);
1362 sk->sk_state = BT_LISTEN;
1363 } else {
--> 1364 iso_conn_defer_accept(pi->conn->hcon);
^^^^^^^^^^^^^^
then we're toast
1365 sk->sk_state = BT_CONFIG;
1366 }
1367 release_sock(sk);
1368 return 0;
1369 case BT_CONNECTED:
1370 if (test_bit(BT_SK_PA_SYNC, |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: Ignore too large handle values in BIG
hci_le_big_sync_established_evt is necessary to filter out cases where the
handle value is belonging to ida id range, otherwise ida will be erroneously
released in hci_conn_cleanup. |
| In the Linux kernel, the following vulnerability has been resolved:
bluetooth/hci: disallow setting handle bigger than HCI_CONN_HANDLE_MAX
Syzbot hit warning in hci_conn_del() caused by freeing handle that was
not allocated using ida allocator.
This is caused by handle bigger than HCI_CONN_HANDLE_MAX passed by
hci_le_big_sync_established_evt(), which makes code think it's unset
connection.
Add same check for handle upper bound as in hci_conn_set_handle() to
prevent warning. |
| In the Linux kernel, the following vulnerability has been resolved:
md/raid5: fix deadlock that raid5d() wait for itself to clear MD_SB_CHANGE_PENDING
Xiao reported that lvm2 test lvconvert-raid-takeover.sh can hang with
small possibility, the root cause is exactly the same as commit
bed9e27baf52 ("Revert "md/raid5: Wait for MD_SB_CHANGE_PENDING in raid5d"")
However, Dan reported another hang after that, and junxiao investigated
the problem and found out that this is caused by plugged bio can't issue
from raid5d().
Current implementation in raid5d() has a weird dependence:
1) md_check_recovery() from raid5d() must hold 'reconfig_mutex' to clear
MD_SB_CHANGE_PENDING;
2) raid5d() handles IO in a deadloop, until all IO are issued;
3) IO from raid5d() must wait for MD_SB_CHANGE_PENDING to be cleared;
This behaviour is introduce before v2.6, and for consequence, if other
context hold 'reconfig_mutex', and md_check_recovery() can't update
super_block, then raid5d() will waste one cpu 100% by the deadloop, until
'reconfig_mutex' is released.
Refer to the implementation from raid1 and raid10, fix this problem by
skipping issue IO if MD_SB_CHANGE_PENDING is still set after
md_check_recovery(), daemon thread will be woken up when 'reconfig_mutex'
is released. Meanwhile, the hang problem will be fixed as well. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: fix mb_cache_entry's e_refcnt leak in ext4_xattr_block_cache_find()
Syzbot reports a warning as follows:
============================================
WARNING: CPU: 0 PID: 5075 at fs/mbcache.c:419 mb_cache_destroy+0x224/0x290
Modules linked in:
CPU: 0 PID: 5075 Comm: syz-executor199 Not tainted 6.9.0-rc6-gb947cc5bf6d7
RIP: 0010:mb_cache_destroy+0x224/0x290 fs/mbcache.c:419
Call Trace:
<TASK>
ext4_put_super+0x6d4/0xcd0 fs/ext4/super.c:1375
generic_shutdown_super+0x136/0x2d0 fs/super.c:641
kill_block_super+0x44/0x90 fs/super.c:1675
ext4_kill_sb+0x68/0xa0 fs/ext4/super.c:7327
[...]
============================================
This is because when finding an entry in ext4_xattr_block_cache_find(), if
ext4_sb_bread() returns -ENOMEM, the ce's e_refcnt, which has already grown
in the __entry_find(), won't be put away, and eventually trigger the above
issue in mb_cache_destroy() due to reference count leakage.
So call mb_cache_entry_put() on the -ENOMEM error branch as a quick fix. |
