| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| An issue was discovered in Das U-Boot through 2019.07. There is an unbounded memcpy with a failed length check at nfs_lookup_reply. |
| An issue was discovered in Das U-Boot through 2019.07. There is an unbounded memcpy with unvalidated length at nfs_readlink_reply in the "else" block after calculating the new path length. |
| An issue was discovered in Das U-Boot through 2019.07. There is an unbounded memcpy with a failed length check at nfs_read_reply when calling store_block in the NFSv2 case. |
| An issue was discovered in Das U-Boot through 2019.07. There is an unbounded memcpy with an unvalidated length at nfs_readlink_reply, in the "if" block after calculating the new path length. |
| An issue was discovered in Das U-Boot through 2019.07. There is an unbounded memcpy when parsing a UDP packet due to a net_process_received_packet integer underflow during an nc_input_packet call. |
| Das U-Boot versions 2016.09 through 2019.07-rc4 can memset() too much data while reading a crafted ext4 filesystem, which results in a stack buffer overflow and likely code execution. |
| In Das U-Boot versions 2016.11-rc1 through 2019.07-rc4, an underflow can cause memcpy() to overwrite a very large amount of data (including the whole stack) while reading a crafted ext4 filesystem. |
| A buffer overflow issue was addressed with improved memory handling. This issue is fixed in iOS 18.7.7 and iPadOS 18.7.7, iOS 26.4 and iPadOS 26.4, macOS Sequoia 15.7.5, macOS Sonoma 14.8.5, macOS Tahoe 26.4, visionOS 26.4. Parsing a maliciously crafted file may lead to an unexpected app termination. |
| In the Linux kernel, the following vulnerability has been resolved:
bnxt_en: Fix memory corruption when FW resources change during ifdown
bnxt_set_dflt_rings() assumes that it is always called before any TC has
been created. So it doesn't take bp->num_tc into account and assumes
that it is always 0 or 1.
In the FW resource or capability change scenario, the FW will return
flags in bnxt_hwrm_if_change() that will cause the driver to
reinitialize and call bnxt_cancel_reservations(). This will lead to
bnxt_init_dflt_ring_mode() calling bnxt_set_dflt_rings() and bp->num_tc
may be greater than 1. This will cause bp->tx_ring[] to be sized too
small and cause memory corruption in bnxt_alloc_cp_rings().
Fix it by properly scaling the TX rings by bp->num_tc in the code
paths mentioned above. Add 2 helper functions to determine
bp->tx_nr_rings and bp->tx_nr_rings_per_tc. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: fix u8 overflow in SSID scan buffer size calculation
The variable valuesize is declared as u8 but accumulates the total
length of all SSIDs to scan. Each SSID contributes up to 33 bytes
(IEEE80211_MAX_SSID_LEN + 1), and with WILC_MAX_NUM_PROBED_SSID (10)
SSIDs the total can reach 330, which wraps around to 74 when stored
in a u8.
This causes kmalloc to allocate only 75 bytes while the subsequent
memcpy writes up to 331 bytes into the buffer, resulting in a 256-byte
heap buffer overflow.
Widen valuesize from u8 to u32 to accommodate the full range. |
| In the Linux kernel, the following vulnerability has been resolved:
bnxt_en : Fix memory out-of-bounds in bnxt_fill_hw_rss_tbl()
A recent commit has modified the code in __bnxt_reserve_rings() to
set the default RSS indirection table to default only when the number
of RX rings is changing. While this works for newer firmware that
requires RX ring reservations, it causes the regression on older
firmware not requiring RX ring resrvations (BNXT_NEW_RM() returns
false).
With older firmware, RX ring reservations are not required and so
hw_resc->resv_rx_rings is not always set to the proper value. The
comparison:
if (old_rx_rings != bp->hw_resc.resv_rx_rings)
in __bnxt_reserve_rings() may be false even when the RX rings are
changing. This will cause __bnxt_reserve_rings() to skip setting
the default RSS indirection table to default to match the current
number of RX rings. This may later cause bnxt_fill_hw_rss_tbl() to
use an out-of-range index.
We already have bnxt_check_rss_tbl_no_rmgr() to handle exactly this
scenario. We just need to move it up in bnxt_need_reserve_rings()
to be called unconditionally when using older firmware. Without the
fix, if the TX rings are changing, we'll skip the
bnxt_check_rss_tbl_no_rmgr() call and __bnxt_reserve_rings() may also
skip the bnxt_set_dflt_rss_indir_tbl() call for the reason explained
in the last paragraph. Without setting the default RSS indirection
table to default, it causes the regression:
BUG: KASAN: slab-out-of-bounds in __bnxt_hwrm_vnic_set_rss+0xb79/0xe40
Read of size 2 at addr ffff8881c5809618 by task ethtool/31525
Call Trace:
__bnxt_hwrm_vnic_set_rss+0xb79/0xe40
bnxt_hwrm_vnic_rss_cfg_p5+0xf7/0x460
__bnxt_setup_vnic_p5+0x12e/0x270
__bnxt_open_nic+0x2262/0x2f30
bnxt_open_nic+0x5d/0xf0
ethnl_set_channels+0x5d4/0xb30
ethnl_default_set_doit+0x2f1/0x620 |
| In the Linux kernel, the following vulnerability has been resolved:
dpaa2-switch: validate num_ifs to prevent out-of-bounds write
The driver obtains sw_attr.num_ifs from firmware via dpsw_get_attributes()
but never validates it against DPSW_MAX_IF (64). This value controls
iteration in dpaa2_switch_fdb_get_flood_cfg(), which writes port indices
into the fixed-size cfg->if_id[DPSW_MAX_IF] array. When firmware reports
num_ifs >= 64, the loop can write past the array bounds.
Add a bound check for num_ifs in dpaa2_switch_init().
dpaa2_switch_fdb_get_flood_cfg() appends the control interface (port
num_ifs) after all matched ports. When num_ifs == DPSW_MAX_IF and all
ports match the flood filter, the loop fills all 64 slots and the control
interface write overflows by one entry.
The check uses >= because num_ifs == DPSW_MAX_IF is also functionally
broken.
build_if_id_bitmap() silently drops any ID >= 64:
if (id[i] < DPSW_MAX_IF)
bmap[id[i] / 64] |= ... |
| In the Linux kernel, the following vulnerability has been resolved:
net: do not pass flow_id to set_rps_cpu()
Blamed commit made the assumption that the RPS table for each receive
queue would have the same size, and that it would not change.
Compute flow_id in set_rps_cpu(), do not assume we can use the value
computed by get_rps_cpu(). Otherwise we risk out-of-bound access
and/or crashes. |
| In the Linux kernel, the following vulnerability has been resolved:
arm64/sme: Set new vector length before reallocating
As part of fixing the allocation of the buffer for SVE state when changing
SME vector length we introduced an immediate reallocation of the SVE state,
this is also done when changing the SVE vector length for consistency.
Unfortunately this reallocation is done prior to writing the new vector
length to the task struct, meaning the allocation is done with the old
vector length and can lead to memory corruption due to an undersized buffer
being used.
Move the update of the vector length before the allocation to ensure that
the new vector length is taken into account.
For some reason this isn't triggering any problems when running tests on
the arm64 fixes branch (even after repeated tries) but is triggering
issues very often after merge into mainline. |
| In the Linux kernel, the following vulnerability has been resolved:
alpha: fix user-space corruption during memory compaction
Alpha systems can suffer sporadic user-space crashes and heap
corruption when memory compaction is enabled.
Symptoms include SIGSEGV, glibc allocator failures (e.g. "unaligned
tcache chunk"), and compiler internal errors. The failures disappear
when compaction is disabled or when using global TLB invalidation.
The root cause is insufficient TLB shootdown during page migration.
Alpha relies on ASN-based MM context rollover for instruction cache
coherency, but this alone is not sufficient to prevent stale data or
instruction translations from surviving migration.
Fix this by introducing a migration-specific helper that combines:
- MM context invalidation (ASN rollover),
- immediate per-CPU TLB invalidation (TBI),
- synchronous cross-CPU shootdown when required.
The helper is used only by migration/compaction paths to avoid changing
global TLB semantics.
Additionally, update flush_tlb_other(), pte_clear(), to use
READ_ONCE()/WRITE_ONCE() for correct SMP memory ordering.
This fixes observed crashes on both UP and SMP Alpha systems. |
| uuid is for the creation of RFC9562 (formerly RFC4122) UUIDs. Prior to 14.0.0, v3, v5, and v6 accept external output buffers but do not reject out-of-range writes (small buf or large offset). This allows silent partial writes into caller-provided buffers. This vulnerability is fixed in 14.0.0. |
| In the Linux kernel, the following vulnerability has been resolved:
NFSv4: Fix an Oops in pnfs_mark_request_commit() when doing O_DIRECT
Fix an Oopsable condition in pnfs_mark_request_commit() when we're
putting a set of writes on the commit list to reschedule them after a
failed pNFS attempt. |
| The OpenFeature feature toggle evaluation endpoint reads unbounded values into memory, which can cause out-of-memory crashes. |
| A stack based buffer overflow exists in an API route of XWEB Pro version
1.12.1 and prior, enabling unauthenticated attackers to cause stack
corruption and a termination of the program. |
| Out of bounds memory access in V8 in Google Chrome prior to 148.0.7778.96 allowed a remote attacker to execute arbitrary code inside a sandbox via a crafted HTML page. (Chromium security severity: High) |
